The composite signal from the exciter or other source is connected to the input of the CDA-104, and four composite signal outputs are then available, each with its own adjustable gain. The gain controls for each output are conveniently located on the front panel.
Input and output connectors are the BNC type, to interconnect readily with most types of equipment.
Power Requirements | 115 VAC, 60 Hz or 230 VAC, 50 Hz; 5 W |
---|
Number of Inputs | 1 |
---|---|
Input Impedance | 20 kohms, unbalanced |
Input Signal Level | 3.5 V p-p (1.24 VRMS) nominal, |
21 V p-p (7.4 VRMS) maximum at unity gain | |
Input Connector | BNC |
Number of Outputs | 4 |
---|---|
Output Impedance | 33 ohms, unbalanced |
Output Level | 3.5 V p-p (1.24 VRMS) nominal, |
21 V p-p (7.4 VRMS) maximum | |
Output Gain Range | +/-6 dB |
Output Connectors | BNC x 4 |
DC Offset | Less than 20 mV |
Frequency Response | 20 Hz to 100 kHz +0/-0.5 dB |
T. H. D. + Noise | Less than .022%, 20 Hz to 100 kHz, nominal output |
Signal to Noise Ratio | 106 dB, A-wieghted, 500 kHz bandwidth |
CDA-104 | 8.1 W x 1.9 H x 5.1 D |
---|
CDA-104 | Stand alone Table Top Version |
CDA-104/R1 | 1 Unit Rack Mounted in 1 RU Frame. Unit takes 1/2 of the rack frame |
CDA-104/R2 | 2 Units Rack Mounted in 1 RU Frame |
CDA-104/A | Assembly unit only. Ordered for existing Frames |
CDA-104/M | Manual |
PH-3/FR | Phase 3 Rack Frame with no Products Installed |
PH-3/BF | Phase 3 Blank Front Panel plate |
PH-3/BR | Phase 3 Blank Rear Panel Plate |
PH-3/DB | Phase 3 Under the Desk Mounting Bracket |