On the LM-2, two channels provide conversion from high-level balanced signals (typically +4 or +8 dBm) to low-level unbalanced signals (typically -10 or -20 dBV). Two other channels provide conversion from low-level unbalanced to high-level balanced signals.
Gain adjustments for each of the four channels are readily accessible from the front panel, in order to accommodate a wide range of signal amplitudes.
| Power Requirements | 115 VAC, 60 Hz or 230 VAC, 50 Hz; 4.5 W |
|---|
| Input Impedance | 40 kohms balanced |
|---|---|
| Input Signal Level | +4 dBm nominal, +24 dBm maximum |
| Input Connectors | XLR, female |
| Output Load Impedance | 10 kohms nominal |
| Output Signal Level | -10 dBV nominal, +18 dBV maximum |
| Output Level Control Range | -22 to +3 dBV @ +4 dBm input |
| Output Connectors | RCA |
| Frequency Response | 20 Hz to 30 kHz +/-0.1 dB |
| T. H. D. + Noise | .017%, 20 Hz to 30 kHz, nominal output |
| Common Mode Rejection | -79 dB @ 60 Hz |
| Input Impedance | 100 kohms unbalanced |
|---|---|
| Input Signal Level | -10 dBV nominal, +18 dBV maximum |
| Input Connectors | RCA |
| Output Load Impedance | 600 ohms nominal |
| Output Signal Level | +4 dBm nominal, +24 dBm maximum |
| Output Level Control Range | -3 to +24 dBm @ -10 dBV input |
| Output Connectors | XLR, male |
| Frequency Response | 20 Hz to 30 kHz +/-0.2 dB |
| T. H. D. + Noise | Less than .014%, 20 Hz to 30 kHz, nominal output |
| Hum and Noise | -88 dBm, 20 Hz to 30 kHz |
| LM-2 | 8.1 W x 1.9 H x 5.1 D |
|---|
| LM-2 | Stand alone Table Top Version |
| LM-2/R1 | 1 Unit Rack Mounted in 1 RU Frame. Unit takes 1/2 of the rack frame |
| LM-2/R2 | 2 Units Rack Mounted in 1 RU Frame |
| LM-2/A | Assembly unit only. Ordered for existing Frames |
| LM-2/M | Manual |
| PH-3/FR | Phase 3 Rack Frame with no Products Installed |
| PH-3/BF | Phase 3 Blank Front Panel plate |
| PH-3/BR | Phase 3 Blank Rear Panel Plate |
| PH-3/DB | Phase 3 Under the Desk Mounting Bracket |
