Input selections may be made using the front panel switches, or remotely, using simple switch or relay closures via the rear panel remote connector.
All inputs and outputs use standard SVHS connectors. The output gain for Y and C and frequency response of the Y component are internally adjustable. All switching occurs during the vertical interval of the output video.
When coupled with the RS-41A, a complete 4x1 video/stereo audio dubbing/routing system is obtained, complete with breakaway.
Power Requirements | 115 VAC, 60 Hz or 230 VAC, 50 Hz; 3 W |
---|
Number of Inputs | 4 |
---|---|
Input Impedance | 75 ohms, terminating |
Input Signal Level | 1 V p-p nominal, 2 V p-p maximum |
Input Connectors | Standard SVHS x 4 |
DC Offset | +1.4/-0.7 V maximum |
Crosstalk | -60 dB to 4.2 MHz |
---|---|
Path Length Differential | Less than 1 degree @ 3.58 MHz |
Switching Bounce | Less than 2 IEEE units (14 mV) |
Switch Timing | Vertical interval |
Number of Outputs | 2 |
---|---|
Load Impedance | 75 ohms |
Output Level | 1 V p-p nominal, 2 V p-p maximum |
Output Gain Range | +3.5/-0.7 dB |
Output Connectors | Standard SVHS x 2 |
DC Offset | Less than 50 mV |
Frequency Response | +0/-0.05 dB to 15 MHz, +0/-0.4 dB to 20 MHz |
Differential Gain | Less than 0.1%, 10-90% APL, 2 loads |
Differential Phase | Less than 0.1 deg., 10-90% APL, 2 loads |
Horizontal Tilt | Less than 0.1% |
Vertical Tilt | Less than 0.3%, composite field square wave |
RS-41S | 8.1 W x 1.9 H x 5.1 D |
---|