Input selections may be made using the front panel switches, or remotely, using simple switch or relay closures via the rear panel remote connector.
All video inputs and outputs use BNC connectors. The output gain and frequency response are internally adjustable. All switching occurs during the vertical interval of the output video.
When coupled with the RS-41A, a complete 4x1 video/stereo audio dubbing/routing system is obtained, complete with breakaway.
| Power Requirements | 115 VAC, 60 Hz or 230 VAC, 50 Hz; 3 W |
|---|
| Number of Inputs | 4 |
|---|---|
| Input Impedance | 75 ohms, terminating |
| Input Signal Level | 1 V p-p nominal, 2 V p-p maximum |
| Input Connectors | BNC x 4 |
| DC Offset | +1.4/-0.7 V maximum |
| Crosstalk | -60 dB to 4.2 MHz |
|---|---|
| Path Length Differential | Less than 1 degree @ 3.58 MHz |
| Switching Bounce | Less than 2 IEEE units (14 mV) |
| Switch Timing | Vertical interval |
| Number of Outputs | 2 |
|---|---|
| Load Impedance | 75 ohms |
| Output Level | 1 V p-p nominal, 2 V p-p maximum |
| Output Gain Range | +3.5/-0.7 dB |
| Output Connectors | BNC x 2 |
| DC Offset | Less than 50 mV |
| Frequency Response | +0/-0.05 dB to 15 MHz, +0/-0.4 dB to 20 MHz |
| Differential Gain | Less than 0.1%, 10-90% APL, 2 loads |
| Differential Phase | Less than 0.1 deg., 10-90% APL, 2 loads |
| Horizontal Tilt | Less than 0.1% |
| Vertical Tilt | Less than 0.3%, composite field square wave |
| RS-41V | 8.1 W x 1.9 H x 5.1 D |
|---|
